4 Channel DMX Controller/Decoder can control up to 4 different 12VDC LED products or any RGB LED Light Bar or Strip. Controller can run in stand alone mode using Address code switches or under DMX-512 digital control signals using XLR or RJ45 DMX-512 Input/Output interfaces. DMX decoding driver converts universal DMX512/1990 digital signal to PWM signal, which can be controlled by DMX512 console with 16-bit gray scale output per channel. Maximum load is 5 Amps per channel - 20 Amps total. Includes male and female 3-pin XLR connectors.
|Function:||Control four different 12VDC LED products or 1 RGB LED and 1 single color LED product using DMX console or standalone mode with onboard DIP switches|
|Applications:||Neccessary conversions of DMX to PWM signals for driving LEDs|
|Operating Voltage:||12~24 Volts DC (use only 12VDC power with 12VDC LEDs)|
|Connection Mode:||Common Anode (+)|
|Output:||Four CMOS output|
|Output Power:||240 Watts|
|Maximum Load Current:||5 Amps/channel (20 Amps total)|
|Control Method:||DMX512 RJ45 / DMX512 3-pin XLR / Standalone DIP switches|
|Standalone Modes:||9 total (7 static and 2 dynamic) see desc. below|
|Overall Size:||(L)166 X (W)67 X (H)41 mm|
The Model DMX-4C5A can run on stand alone mode or under DMX control. It receives standard DMX-512 digital control signals and converts to PWM (pulse width modulation) signals for driving LEDs. Connect to any DMX digital console to achieve dimming and and various color changing patterns.
1.) Only power with 12VDC Power Supply to connect to 12 Volt Light Strips or unit will be damaged. Our Enclosed Power Supplies can be direct wired to "+" and "-" terminals on removable Green connector on side of unit.
2.) Connect according to the above drawing and note that the Green Connectors can be unplugged from the unit.
3.) Do not exceed 80% of Power Supply capacity when calculating Power Supply size to use in your system.
4.) Not suitable for automobile applications
1.) Standalone mode is activated when FUN(10)=ON, the following functions can be set using address codes DIP switch
|Switch 8=ON||Seven Color Change Instant (speed function activated - see coding below)|
|Switch 9=ON||Seven Color Change Fading (speed function activated - see coding below)|
|Coding Switch||Speed Function (When 8 or 9=ON and 10=ON)|
|Switch 1-7=OFF||Slowest Color Change Mode|
|Switch 1=ON||1 Step Faster|
|Switch 2=ON||2 Steps Faster|
|Switch 7=ON||Fastest Color Change Mode|
2.) DMX signal can be received when FUN(10)=OFF, along with using either the DMX512 RJ45 input/output interface or the DMX512 3-pin XLR input/output interface